|
web
newsgroups
|
|||||||||||||||||||||||
|
|||||||||||||||||||||||
Corrupted c:\winnt\system32\config\system fileI am unable to boot into my main Win2k installation because at bootup time a
message comes up that says that c:\winnt\system32\config\system is corrupted. Is there any way out of this predicament ? I tried using my Win2k CD-ROM and my Emergency Repair Disk but evidently there was no backup of this file which could be used to restore a non-corrupted version. Am I completely hosed or is there a way to get a non-corrupt system file somehow so that I can boot into my main Win2k installation. If I am hosed it will naturally be onerous for me to configure my secondary Win2k installation with all the software and registry settings that I have built up over the years in my main Win2k installation. If the system hive is corrupt, and assuming you already tried LKG (F8 and
choose Last Known Good), It may be possible to rename the system hive found in %windir%\system32\config\system to system.old then rename %windir%\system32\config\system.alt to %windir%\system32\config\system You can also try using the most recent backup found in %windir%\repair\regback If that fails you haven't much choice but to copy/ use the original-as-installed system hive from %windir%\repair\system to %windir%\system32\config\system You'll need to reinstall the device drivers for any hardware added since the original OS install. To start the Recovery Console, start the computer from the Windows 2000 Setup CD or the Windows 2000 Setup floppy disks. If you do not have Setup floppy disks and your computer cannot start from the Windows 2000 Setup CD, use another Windows 2000-based computer to create the Setup floppy disks. Press ENTER at the "Setup Notification" screen. Press R to repair a Windows 2000 installation, and then press C to use the Recovery Console. The Recovery Console then prompts you for the administrator password. If you do not have the correct password, Recovery Console does not allow access to the computer. If an incorrect password is entered three times, the Recovery Console quits and restarts the computer. Note If the registry is corrupted or missing or no valid installations are found, the Recovery Console starts in the root of the startup volume without requiring a password. You cannot access any folders, but you can carry out commands such as chkdsk, fixboot, and fixmbr for limited disk repairs. Once the password has been validated, you have full access to the Recovery Console, but limited access to the hard disk. You can only access the following folders on your computer: drive root, %systemroot% or %windir% -- Show quoteHide quoteRegards, Dave Patrick ....Please no email replies - reply in newsgroup. Microsoft Certified Professional Microsoft MVP [Windows] http://www.microsoft.com/protect "Edward Diener" <eldie***@earthlink.net> wrote in message news:esuif7zKFHA.688@TK2MSFTNGP10.phx.gbl... |I am unable to boot into my main Win2k installation because at bootup time a | message comes up that says that c:\winnt\system32\config\system is | corrupted. Is there any way out of this predicament ? I tried using my Win2k | CD-ROM and my Emergency Repair Disk but evidently there was no backup of | this file which could be used to restore a non-corrupted version. Am I | completely hosed or is there a way to get a non-corrupt system file somehow | so that I can boot into my main Win2k installation. If I am hosed it will | naturally be onerous for me to configure my secondary Win2k installation | with all the software and registry settings that I have built up over the | years in my main Win2k installation. | | Thanks ! I could not recover no matter what I did so I will have to
re-install and build up my system from scratch. At least the files I had are still there so it is just a case of re-installing software so the correct settings are made in the registry again. I was surpised that an emergency repair disk does not restore an older version of the registry if it gets hosed. Show quoteHide quote "Dave Patrick" <mail@Nospam.DSPatrick.com> wrote in message news:OHUXq50KFHA.1948@TK2MSFTNGP14.phx.gbl... > If the system hive is corrupt, and assuming you already tried LKG (F8 and > choose Last Known Good), It may be possible to rename the system hive found > in > %windir%\system32\config\system > to system.old > then rename > %windir%\system32\config\system.alt > to > %windir%\system32\config\system > > You can also try using the most recent backup found in > %windir%\repair\regback > > If that fails you haven't much choice but to copy/ use the > original-as-installed system hive from > %windir%\repair\system > to > %windir%\system32\config\system > You'll need to reinstall the device drivers for any hardware added since the > original OS install. > > To start the Recovery Console, start the computer from the Windows 2000 > Setup CD or the Windows 2000 Setup floppy disks. If you do not have Setup > floppy disks and your computer cannot start from the Windows 2000 Setup CD, > use another Windows 2000-based computer to create the Setup floppy disks. > Press ENTER at the "Setup Notification" screen. Press R to repair a Windows > 2000 installation, and then press C to use the Recovery Console. The > Recovery Console then prompts you for the administrator password. If you do > not have the correct password, Recovery Console does not allow access to the > computer. If an incorrect password is entered three times, the Recovery > Console quits and restarts the computer. Note If the registry is corrupted > or missing or no valid installations are found, the Recovery Console starts > in the root of the startup volume without requiring a password. You cannot > access any folders, but you can carry out commands such as chkdsk, fixboot, > and fixmbr for limited disk repairs. Once the password has been validated, > you have full access to the Recovery Console, but limited access to the hard > disk. You can only access the following folders on your computer: drive > root, %systemroot% or %windir% > > > -- > Regards, > > Dave Patrick ....Please no email replies - reply in newsgroup. > Microsoft Certified Professional > Microsoft MVP [Windows] > http://www.microsoft.com/protect > > "Edward Diener" <eldie***@earthlink.net> wrote in message > news:esuif7zKFHA.688@TK2MSFTNGP10.phx.gbl... > |I am unable to boot into my main Win2k installation because at bootup time > a > | message comes up that says that c:\winnt\system32\config\system is > | corrupted. Is there any way out of this predicament ? I tried using my > Win2k > | CD-ROM and my Emergency Repair Disk but evidently there was no backup of > | this file which could be used to restore a non-corrupted version. Am I > | completely hosed or is there a way to get a non-corrupt system file > somehow > | so that I can boot into my main Win2k installation. If I am hosed it will > | naturally be onerous for me to configure my secondary Win2k installation > | with all the software and registry settings that I have built up over the > | years in my main Win2k installation. > | > | > > Depending on the damage it may be a manual process, but yes the files are
there. -- Show quoteHide quoteRegards, Dave Patrick ....Please no email replies - reply in newsgroup. Microsoft Certified Professional Microsoft MVP [Windows] http://www.microsoft.com/protect "Edward Diener" wrote: | Thanks ! I could not recover no matter what I did so I will have to | re-install and build up my system from scratch. At least the files I had are | still there so it is just a case of re-installing software so the correct | settings are made in the registry again. | | I was surpised that an emergency repair disk does not restore an older | version of the registry if it gets hosed. .....Those reporting the error "'WINNT\SYSTEM32\CONFIG\SYSTEMced" is in
effect, a "winnt\system32\config\system" error. The error is displayed
over the Windows text "...advanced windows options...."
In my case, I had no floppy drive, and booting to recovery console would not allow me access to copy, paste, or even 'cd' to another directory. As I had critical applications/data on my system, I didn't want to reinstall, due to fear of losing everything. I rebooted the system with the CD, and chose to install to another location (I chose \winnt2\). When I rebooted, I couldn't login because of a missing dll. I then booted from the CD again, and chose to repair, and had the system find the installation. It couldn't find \winnt2\, but it found the \winnt\ folder and repaired it fine. I still have to reinstall IE, as it reverted back to IE5, but at least I didn't lose anything critical. Just thought I'd provide another option. (btw...this whole mess began with a blue screen of death during an uninstall of JDK1.4.2.) -- spc_123 ------------------------------------------------------------------------ Posted via http://www.webservertalk.com ------------------------------------------------------------------------ View this thread: http://www.webservertalk.com/message960772.html |
|||||||||||||||||||||||